Search results for: 'raspberry pi global positioning system'

This GPS module is well known amongst the community and is often used with the ArduCopter gear. At the core is a U-blox Neo-6 GPS receiver which has advanced power management and anti-jamming technology. The module takes care of all the hardware requirements leaving only 4 connections to your micro/external application (Vcc RX TX Gnd).

This GPS receiver brings much more accurate and faster positioning performance with stronger signal compared with traditional GPS receivers. It is compact, lightweight...

This is an Ublox chip-based GPS receiver module of low power and high sensitivity that can receive 56 channels satellite signal. Compared with traditional GPS receivers...

SIM7080G NB-IoT / Cat-M(EMTC) / GNSS Module For Raspberry Pi Pico, Global Band Support...

With GPS you are able to know where you are, where you're going, and how to get there anywhere on Earth within 30 seconds. This means the higher the accuracy the...

This miniature GPS breakout is only 1" x 1" (~ 25mm x 25mm) but houses a complete GPS/GNSS solution with both I2C and UART interfaces. There's even an antenna on...

The SparkFun NEO-M8U GPS Breakout is a high quality, GPS board with equally impressive configuration options. The NEO-M8U takes advantage of u-blox's Untethered...

Cat-1/GNSS HAT for Raspberry Pi, Based On SIM7670G module, Global Multi-band LTE 4G Cat-1 support, GNSS positioning, 3x USB 2.0 extended ports...

The module combines GNSS positioning and RTC functionality. Provides precise longitude, latitude, and altitude data. Compatible with Arduino, ESP32, and...

NB-IoT/Cat-M(eMTC)/GNSS HAT for Raspberry Pi, Based on SIM7080G, Globally Applicable...

Achieve centimeter-level accuracy with out-of-the-box GNSS-RTK Positioning Kit. Pre-configured LoRa data link for easy setup. US 915 MHz, For UAVs, device...

SIM7600G-H 4G CAT4 and GNSS positioning module, supports LTE-FDD, LTE-TDD, WCDMA, GSM, and can be used with Raspberry Pi and LattePanda SBCs for data,...

Equipped with GNSS and multi-band NB-IoT support, the SIM7070G module is perfect for global IoT projects. It offers high-speed data transfer, extensive...

The SparkFun ZED-F9R GPS-RTK Breakout is a high-precision Automotive Dead Reckoning board with equally impressive configuration options...

SIM7600G, a 4G CAT1 and GNSS positioning module, supports LTE-FDD, LTE-TDD, WCDMA, GSM, and can be used with Raspberry Pi and LattePanda SBCs for data,...

With GPS you are able to know where you are, where you’re going, and how to get there anywhere on Earth within 30seconds. This means the higher the accuracy the...

A9G is a complete quad-band GSM/GPRS+GPS module based on the RDA8955 chip. The cost reduction of the core chip provides users with a cost-effective IoT solution...

With GPS you are able to know where you are, where you’re going, and how to get there anywhere on Earth within 30 seconds. This means the higher the accuracy the...

This module is the best way to add a GPS to your wearable project. It's part of the Adafruit Flora series of wearable electronics, designed specifically for use with the Flora motherboard. Installed on the PCB is the latest of our Ultimate GPS modules, a small, super-thin, low power GPS module with built in data-logging capability! This module's easy to use, but extremely powerful!