A joy-bringing little humanoid robot that walks, dances and can map a room on its own. Control, program and learn.

Cap off a length of goTUBE and give it a proper flange - four M4 screws, and the tube is constrained on one end.

Ten-point touch, wide-gamut colour and a toughened glass front, all driven from a single DSI ribbon on your Raspberry Pi.

Bring programmable switching to a DIN rail - high-power relays, isolated field inputs and a wired network connection in one unit.

Strip rust and old paint back to bare metal in a single pass, 45mm wide to make quick work of whatever you need to clean.

All of the extra accessories you need to unlock the full capability of the M2 - allowing for the full print, cut and engrave process on flat and round materials.

Turn a Compute Module 5 into a DIN-rail mountable industrial controller with dual Ethernet, isolated serial and 4G-ready expansion.

Prop your Pi 5 touchscreen at any angle, protect its exposed back, and keep every port within reach.

Prop your Pi 5 touchscreen at any angle, protect its exposed back, and keep every port within reach.

Built for always-on projects that never stop reading and writing. Rated for 30,000 hours of continuous use, so your logger or Pi doesn't randomly stop working because of a worn-out card.

Crisp 640×480 IPS touch in a 3.5-inch footprint, driven over plain HDMI - no GPIO pins used, and it works with any Pi, Jetson or PC.

2K resolution packed into 5.5 inches, with optically bonded 10-point touch over HDMI — dense enough that individual pixels disappear.

Genuine 40 ml CMYK ink for the M2's inkjet module, up to 800 pages of full-colour printing on paper, wood, and other materials.

A pocket-sized dual-core board pairing a vivid 368×448 AMOLED touchscreen with six-axis motion sensing and onboard audio.

Sharp 720 × 1280 IPS touch panel that bolts straight onto a Raspberry Pi and leaves every GPIO pin free.

This timing breakout provides 5ns timing accuracy, multi-band reception and Qwiic connectivity for synchronised systems.

Adds true metal engraving to your colour craft laser - permanent marks on jewellery, tools and tumblers, with no unnecessary steps.

Turn your xTool M2 into a rotary engraver for tumblers, mugs, rings and spheres - magnetic attachments swap over in seconds, no tools required.

Turn print-then-cut into a single seamless process - full CMYK at 1200 DPI, then laser cutting with no realignment.

A tiny buck regulator that turns up to 72 V into a steady 5 V at ~1.1 A, with up to 95% efficiency, soft-start, short-circuit and thermal protection, and an enable pin. 0.1" pads that suit breadboards and headers.

Print in full colour, then cut it out on the same desktop machine. 20W of diode power handles more materials without a second pass.

Add a crisp, high-contrast user interface to your project with this compact 1.5-inch OLED display, featuring effortless Qwiic integration and low power consumption.

A 1280×800 IPS panel with 10-point touch and built-in speakers — plug into a Pi, mini PC or phone over one Type-C cable.