Search results for: 'complementary metal-oxide-semiconductor'

45 results

N-channel Mosfet - 2N7000

When you need to switch a lot of power, N channel MOSFETs are best for the job.
$0.82 AUD, inc GST

Nucleo-F446RE (STM32F446RE)

NUCLEO-F446RE, STM32 Nucleo development board with STM32F446RET6 MCU
$55.50 AUD, inc GST

N-channel power MOSFET - 30V / 60A

Brand: Adafruit
When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit nicely...
$4.20 AUD, inc GST

SparkFun Discrete Semiconductor Kit

Brand: Sparkfun
If you do anything with electronics, you’re probably already using transistors, but you’re probably using them in large, prepackaged clusters of just one type. The SparkFun Discrete Semiconductor Kit addresses your needs of only needing one or a couple transistors without you needing go and order a single transistor. Inside each kit you will find multiple types of semiconductors including PNP and NPN bipolar transistors, N-channel and P-channel MOSFETs, diodes, adjustable voltage references, and adjustable voltage regulators.
$41.30 AUD, inc GST

74AHCT14 - Logic Level Inverter / Level Shifter

Brand: Adafruit
Sometimes you feel low, and sometimes you feel high - cause your logic levels are opposite what they should be! But this easy-to-use inverter chip will flip that...
$1.95 AUD, inc GST

Mini MOSFET Slide Switch with Reverse Voltage Protection, LV

Brand: Pololu
This breadboard-compatible module is an alternative to bulky power switches. It uses a small integrated slide switch to control a high-side power MOSFET...
$7.40 AUD, inc GST

4017 Decade Counter/Divider CMOS IC

4017 Decade Counter/Divider CMOS IC (Complementary Metal-Oxide-Semiconductor) logic chips are popular due to their lower power consumption, wider range of power supply voltages (3-15V) than those offered by TTL (Transistor-Transistor Logic) and a reduced need for extraneous circuitry, simplifying the design process and reducing circuit board size.
$1.65 AUD, inc GST

MOSFET P-CH, 60V, 900mA (ZXMP6A13FTA)

Brand: Sparkfun
This is a common MOSFET with very low on-resistance and a control voltage (aka gate voltage) that is compatible with any 3-5V microcontroller or...
$1.10 AUD, inc GST

SparkFun MicroMod Alorium Sno M2 Processor

The SparkFun MicroMod Alorium Sno Processor features the Sno System on Module (SoM) adapted to the MicroMod M.2 processor form factor...
$91.05 AUD, inc GST

MOSFET N/P-CH - 30V, 2.7/2.0A (IRF7509)

Brand: Sparkfun
The IRF7509 is a very common MOSFET with very low on-resistance and a control voltage (aka gate voltage) that is compatible with most 5V microcontroller...
$1.15 AUD, inc GST

Adafruit MOSFET Driver - For Motors, Solenoids, LEDs, etc - STEMMA JST PH 2mm

Brand: Adafruit
Sparky the Blue Smoke Monster shows up whenever the magic smoke is let of of an electronic component. And his very favorite is whenever folks first start...
$7.55 AUD, inc GST

MOSFET Module (Screw terminals)

Brand: Core Electronics

Keep your IO protected and drive high-power outputs.

$1.80 AUD, inc GST

Pololu RC Switch with Medium Low-Side MOSFET

Brand: Pololu
This RC switch converts hobby radio control pulses to digital on/off signals and has an integrated medium, low-side MOSFET that allows it to drive moderate loads (up to around 15 A), such as lighting or small actuators. The activation threshold and direction are configurable, and a safe-start feature reduces the likelihood of unexpected activation. The board also includes a linear regulator that allows it to be powered with voltages between 2.5 V and 16 V.
$18.40 AUD, inc GST

Mini MOSFET Slide Switch with Reverse Voltage Protection, SV

Brand: Pololu
This breadboard-compatible module is an alternative to bulky power switches. It uses a small integrated slide switch to control a high-side power MOSFET that can deliver continuous currents up to around 4 A at 4.5 V to 40 V. The board features reverse-voltage protection and also makes it easy to control the MOSFET with an external switch or the digital output of a microcontroller.
$7.60 AUD, inc GST

SOIC to DIP Adapter 20 Pin

Brand: AB Electronics
This breakout board is a dual sided PCB with an SOIC 8 package on one side and a SOT23-6 package on the other. The SOIC and SOT23-6 pins are broken out to 0.1" (2.54mm) headers which can be used on breadboards for prototyping your projects.
$2.95 AUD, inc GST

Pololu RC Switch with Small Low-Side MOSFET

Brand: Pololu
This RC switch converts hobby radio control pulses to digital on/off signals and has an integrated small, low-side MOSFET that allows it to drive small loads (up to around 3 A), such as lighting or small actuators. The activation threshold and direction are configurable, and a safe-start feature reduces the likelihood of unexpected activation.
$14.95 AUD, inc GST

Oscillator - 16MHz, 2.0x1.6mm, 50ppm (SMD)

Brand: Sparkfun
This is a standard Crystal Oscillator. It features a 1.6V supply voltage and comes in a 2mm x 1.6mm surface mount package. It offers a ±50PPM frequency...
$3.40 AUD, inc GST

SOIC to DIP Adapter 20-Pin

Brand: Sparkfun
This is a low-cost, basic SOIC breakout boards. This custom PCB will interface a standard SOIC package IC to 0.1" headers, which are easier to work with and integrate well with breadboards.
$8.25 AUD, inc GST
Similar matches

Logic Level Converter Bi-Directional

Brand: Makerverse
This Bi-Directional Logic Level Converter is a breadboard-friendly device that converts between 5V and 3.3V logic.
$2.95 AUD, inc GST

Monochrome 0.96 128x64 I2C/SPI OLED Display

Brand: DFRobot
This 0.96” OLED display module uses the SSD1306 drive chip, has 128x64 self-illuminating white pixels, and adopts two communication methods: SPI/ I2C, I2C in default...
$23.75 AUD, inc GST

Opto-isolator Breakout

Brand: Sparkfun
This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. This board electrically isolates a controller from the high-power system by use of an opto-isolator IC. This IC has two LEDs and two photodiodes built-in. This allows the low-voltage side to control a high voltage side.
$10.35 AUD, inc GST

Monochrome 0.91”128x32 I2C OLED Display

Brand: DFRobot
This OLED display module uses the SSD1306 drive chip, has 128x32 self-illuminating white pixels, and adopts the back chip-mounting pad design. Small size, the length...
$16.40 AUD, inc GST

Pololu Power ORing Ideal Diode Pair, 4-60V, 6A

Brand: Pololu
This module consists of two ideal diode circuits with their outputs connected to form a power ORing arrangement, which can be used for load sharing or for...
$13.15 AUD, inc GST

Adafruit VCNL4040 Proximity and Lux Sensor - STEMMA QT

Brand: Adafruit
The VCNL4040 is a handy two-in-one sensor, with a proximity sensor that works from 0 to 200mm (about 7.5 inches) and light sensor with range of 0.0125 to 6553 lux...
$11.95 AUD, inc GST

Monochrome 0.91”128x32 I2C OLED Display with Chip Pad

Brand: DFRobot
This OLED display module uses the SSD1306 drive chip, has 128x32 self-illuminating white pixels, and adopts the back chip-mounting pad design. Small size, the length...
$16.35 AUD, inc GST

Adafruit ISO1540 Bidirectional I2C Isolator - STEMMA QT / Qwiic

Brand: Adafruit
Sometimes you'll find yourself with an I2C bus controller on one side, and an I2C bus device on the other and you gotta keep em (electrically) separated. Maybe because one is Earth-grounded, maybe because you've got some funky power monitoring setup, maybe you want to reduce noise.
$17.25 AUD, inc GST

Adafruit Bicolor LED Square Pixel Matrix with I2C Backpack

Brand: Adafruit
What's better than a single LED? Lots of LEDs! A fun way to make a small colorful display is to use a 1.2" Bi-color 8x8 LED Matrix. Matrices like these are 'multiplexed'...
$28.95 AUD, inc GST

Gravity: GP8413 2-Channel 15-bit I2C to 0-5V/10V DAC Module

Brand: DFRobot
High-resolution, high-precision, dual-channel DAC voltage module. Expandable to 16 output channels through I2C cascading...
$23.50 AUD, inc GST

SparkFun Micro OLED Breakout (Qwiic)

Brand: Sparkfun
The SparkFun Qwiic Micro OLED Breakout is a Qwiic enabled version of our popular MicroView and micro OLED display!...
$21.55 AUD, inc GST

Adafruit LM66200 Ideal Dual Diodes Breakout

Brand: Adafruit
Most projects these days have multiple power supplies: say a battery or DC wall plug or USB for multiple powering options. Juggling these to have seamless...
$5.10 AUD, inc GST

Big MOSFET Slide Switch with Reverse Voltage Protection, MP

Brand: Pololu
This breadboard-compatible module is an alternative to bulky power switches. It uses a small integrated slide switch to control a high-side power MOSFET...
$9.30 AUD, inc GST

Gravity: CH423 I2C 24 Digital IO Expansion Module

Brand: DFRobot
This CH423 IO expansion board extends 24 digital ports via I2C, including 8 GPIOs with interrupt functions and 16 GPOs...
$8.60 AUD, inc GST

Fermion: MEMS Carbon Monoxide CO Gas Detection Sensor (Breakout, 5-5000ppm)

Brand: DFRobot
Trust in Fermion: MEMS CO detection sensor for accurate, low-power consumption, and compact carbon monoxide detection with minimal heat generation. Keep...
$8.45 AUD, inc GST

SparkFun MicroMod Input and Display Carrier Board

Brand: Sparkfun
The SparkFun MicroMod Input and Display Carrier Board is a great way to add data and input visibility to your MicroMod project. Want to create your own embedded...
$99.45 AUD, inc GST

Pimoroni RGB Potentiometer Breakout

Brand: Pimoroni
Add a colourful light-up dial and turn your Raspberry Pi project up to 11!
$22.25 AUD, inc GST

Crystal Oscillator - TCXO 26MHz, 1.65x1.25mm, SNWV (SMD)

Brand: Sparkfun
This is a Clipped Sine Wave Temperature-Compensated Crystal Oscillator (TCXO). It features a 1.8V supply voltage and comes in a 1.65 x 1.25mm surface...
$7.50 AUD, inc GST

Adafruit VCNL4020 Proximity and Light Sensor - STEMMA QT / Qwiic

Brand: Adafruit
The VCNL4020 is a handy two-in-one sensor, with a proximity sensor that works from 0 to 200mm (about 7.5 inches) and light sensor with range of 0.26 to...
$10.50 AUD, inc GST

Bluno Nano

Brand: DFRobot
Here comes the second member in DFRobot Bluno family, the Bluno Nano. Came in a size of a gum, the Bluno Nano is perfect for BLE projects with limited space or weight.
$40.40 AUD, inc GST

Pololu 38 kHz IR Proximity Sensor, Fixed Gain, Low Brightness

Brand: Pololu
This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This low-brightness version draws an average of 8 mA and has a typical sensing range up to approximately 12 inches (30 cm).
$16.70 AUD, inc GST

Gravity: GP8512: 1-Channel 15bit I2C to 0-2.5V/VCC DAC Module

Brand: DFRobot
High-resolution, high-precision, single-channel DAC voltage output module. Used in control scenarios that demand higher signal accuracy, such as more...
$16.70 AUD, inc GST
Feedback

Please continue if you would like to leave feedback for any of these topics:

  • Website features/issues
  • Content errors/improvements
  • Missing products/categories
  • Product assignments to categories
  • Search results relevance

For all other inquiries (orders status, stock levels, etc), please contact our support team for quick assistance.

Note: click continue and a draft email will be opened to edit. If you don't have an email client on your device, then send a message via the chat icon on the bottom left of our website.

Makers love reviews as much as you do, please follow this link to review the products you have purchased.