Search results for: 'uart converter'

This is an industrial USB to RS485 converter with original FT232RL and SP485EEN inside. It features embedded protection circuits such as lightning-proof, resettable fuse, ESD protection, and TVS diode, etc. It's pretty small in size.

Going from TTL to RS485 is made simple by this prototyping friendly module. On one side of the board are the TTL IOs, and on the other are the RS485. At the core is a MAX485 which is powered by 5V.

USB to RS232/485 Serial Converter, Onboard Original FT232RNL Chip, Multiple devices applicable, Multi-OS compatible...

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USBSerial conversion...

Serial Bus Servo Driver Board, Integrates Servo Power Supply And Control Circuit, Applicable for ST/SC Series Serial Bus Servos, Small In Size, Easy to...

A nifty RS232 (DB9) to Serial converter. Comes with pre-soldered 0.1" male header pins for easy connectivity to breadboards and projects.

isolated RS485 to UART signal transfer module comes with protection circuits such as power isolation and TVS...

2-Channel RS485 Module For Raspberry Pi Pico

If you're looking to interface with telco, retro or industrial equipment you'll probably run into RS-232 interfaces. The Adafruit RS232 Pal - Two...

RainbowLink USB protocol converter with 4 independent channels (RS485, RS232, 2 TTL) designed for efficient multi-channel serial communication. It offers...

This is a simple RS232 to RS485 converter that is self powered using the TX, RX or RTS, CTS signals for power. The RS232 is DB9 female connector, and the RS485 side is a DB9 male or 4 position terminal block.

This is a USB to TTL Serial Cable which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this cable are configured to operate at 3.3V specifically with a Raspberry Pi with each serial pin broken apart. Thanks to its separated pins, this cable is a perfect candidate for powering, connecting, and accessing the login and debug console on the Raspberry Pi.

4 Port USB HUB HAT for Raspberry Pi, USB to UART Onboard...

This IIC to Dual UART module offers data transmission rate up to 1Mbps, and each sub UART has independent 256-byte FIFO hardware buffer for transmitting and receiving. The baud rate, word length, and check format of every sub UART can be set independently.

The Serial Pi Plus is a communication board supporting the RS232 serial protocol.

No matter what serial-esque protocol you need to interface with, this USB to Multi-Protocol Serial adapter cable will be able to get...

This RS232 shield is designed for the Arduino controller,and it can easily convert UART to RS232 interface. The shield integrates DB9 connectors (female) that provide connection to various devices with RS232 interface. Also the RS232 headers will facilitate your connections and commissioning. It provides the welding areas to make full use of extra space on it, which is highly convenient for prototyping. It provides a run / program mode switch. When switched OFF, you'll be able to programme the Arduino controller; When switched ON, you can use the shield normally. Gold immersion PCB. Long pins on the back that are compatible with most Arduino controllers.

Do you always feel like the DIY work is boring, not attractive or no vitality when you design it by yourself? This new Gravity MP3 voice module produced by DFRobot...

No matter what serial-esque protocol you need to interface with, this USB to Multi-Protocol Serial adapter will be able to get this-connected-to-that. It...