Search results for: '4g gps module'

This gold-plated IPEX to SMA female connector can be widely used in WiFi, GPS, 4G, 5G and other modules...

SIM7600G-H M.2 4G HAT For Raspberry Pi, LTE CAT4 High Speed, Global Coverage Multi Band, 4G/3G/2G Compatible, GNSS...

Enable LTE Cat-4 4G/3G/2G communication and GNSS Positioning for your Raspberry Pi

The SIM7600G-H-M.2 is the LTE Cat 4 module which supports wireless communication modes of LTE-TDD, LTE-FDD, HSPA+, GSM, GPRS, EDGE, etc. It supports...

SIM7600G-H 4G CAT4 and GNSS positioning module, supports LTE-FDD, LTE-TDD, WCDMA, GSM, and can be used with Raspberry Pi and LattePanda SBCs for data,...

Cat-1/GNSS HAT for Raspberry Pi, Based On SIM7670G module, Global Multi-band LTE 4G Cat-1 support, GNSS positioning, 3x USB 2.0 extended ports...

SIM7600G, a 4G CAT1 and GNSS positioning module, supports LTE-FDD, LTE-TDD, WCDMA, GSM, and can be used with Raspberry Pi and LattePanda SBCs for data,...

This gold-plated IPEX to SMA male cable(inner needle) passed the 48h salt spray test, which is durable and not easy to rust, and can be widely used in...

The GP-1818MK is a low-cost, high performance GPS module that provides position, velocity, and accurate timing via the NMEA-0183 protocol...

For those who want to integrate Adafruit's awesome Ultimate GPS module into their own projects, Adafruit now have the raw sub-module available. Don't be fooled by it's small...

Support Raspberry Pi model A, B, A+, B+, Zero, 2, 3 with its' L80-39 GPS chip inside. Communicates satellite with UART or USB. CP2102 as USB to UART Bridge...

For those who want to integrate our awesome Ultimate GPS module into their own projects, we now have the raw sub-module available. Don't be fooled by...

This module is the best way to add a GPS to your wearable project. It's part of the Adafruit Flora series of wearable electronics, designed specifically for use with the Flora motherboard. Installed on the PCB is the latest of our Ultimate GPS modules, a small, super-thin, low power GPS module with built in data-logging capability! This module's easy to use, but extremely powerful!

COM.GPS is a satellite positioning module in the M5Stack stacking module series. It is developed based on the NEO-M8N module and is equipped with an active antenna. The NEO-M8 can spend a small amount of time, conduct high-sensitivity acquisition, and keep the system low power consumption. NEO-M8N integrates the 72-channel u-blox M8 GNSS engine, supports multiple GNSS systems: BeiDou, Galileo, GLONASS, GPS / QZSS, allowing simultaneous reception 3 Data from a GNSS system.

This GPS module is well known amongst the community and is often used with the ArduCopter gear. At the core is a U-blox Neo-6 GPS receiver which has advanced power management and anti-jamming technology. The module takes care of all the hardware requirements leaving only 4 connections to your micro/external application (Vcc RX TX Gnd).

Enable 4G LTE cellular connectivity on your LattePanda IOTA with this M.2 B-Key expansion board. It supports 3042 4G modules and includes a Nano-SIM slot,...

Quectel LG290P is a quad-band, multi-constellation high-precision GNSS module...