Search results for: 'fan header'

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

If stacking your boards too high is an issue check out this range of low-profile headers!

A replacement for all kinds of Raspberry Pi 5 Coolers.

Keep your Pi 5 cool, good-looking and protected with this dual-fan case!

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

For six pins you need to interface to at a right angle, these headers would be an easy option.

If stacking your boards too high is an issue check out this range of low-profile headers!

If you've got exactly twenty positions for pins on the edge of your board you want some female headers on to interface with, these headers have you covered.

A must have for your own low-profile PCB designs!

For four pin positions you require a four pin header for, this ought to do the trick.

These are the headers to use when you need a full twelve pins on the edge of your board connected to from the side.

Explore the Argon Poly+ 5 Active Cooling Case Kit featuring high-grade ABS plastic construction, PWM fan control, for your Raspberry Pi 5.