Search results for: 'light dependent resistor for arduino'

BH1750 is a digital Ambient Light Sensor IC with an I2C bus interface. The module does all of the hard work, providing a simple digital value via I2C that represents luminance (Lux).

This Photo Transistor Light Sensor is a simple sensor that detects ambient light. It's kind of the opposite of an LED - when light hits the little chip inside, it...

The LTR390 is one of the few low-cost UV sensors available, and it's a pretty nice one! With both ambient light and UVA sensing with a peak spectral response between 300 and 350nm. You can use it for measuring how much sun you can get before needing to covering up.

Here comes DFRobot's new Analog Ambient Light Sensor. Brand new design and much more convenient to use.

After tens of millions of years of evolution, chameleons have formed a biological instinct where they can change the color of their skin to match their environment. This technique has enabled them to avoid detection from predators.

This is a BH1750 light intensity sensor breakout board with a 16 bit AD converter built-in which can directly output a digital signal, there is no need for complicated calculations.

The waterproof digital IP68 waterproof light sensor with 0-200k lux range and Modbus-RTU 485. For industrial, automotive, outdoor lighting measurement...

This new ambient light sensor is packaged in a transparent semisphere case that offers better light-gathering power. The sensor supports a 0-200klx detection range...

Add a teeny analog light sensor, the ALS PT19 analog light sensor is a great way to upgrade a project that uses a photocell and needs RoHS compliance. Due to the...

Extend your light-sensing spectrum with this analog UV sensor module. It uses a UV photodiode, which can detect the 240-370nm range of light (which covers UVB and...

This Gravity: LTR390-UV sensor from DFRobot provides both ambient light and UV sensing with UV spectral response from 280nm to 430nm and raw data output...

The LilyPad Light Sensor is a sewable breakout board with an ALS-PT19 light sensor built in and ready to use right away. Each sensor outputs voltage between 0V and...

Learn about programming and hardware interaction with Arduino with Kitronik's incredible Inventor's kit! The simple way to learn about creating circuits & code.

The Adafruit LTR-329 Light Sensor a simple and popular low-cost I2C digital light sensor that is easy to integrate into your project for reliable and...

The light sensor Bit can turn your circuit on and off by detecting the brightness or darkness of the environment they are in. control your circuit's with light! The amount of light shining on the sensor will change how your circuit behaves. It's a great way to activate your circuit, and is perfect for alarms!

The Adafruit LTR-303 Light Sensor a simple and popular low-cost I2C digital light sensor that is easy to integrate into your project for reliable and...

Remember when you were a kid and there was a birthday party at the pool and your parents totally embarrassed you by slathering you all over with sunscreen and you...

If you’ve had ideas for a project that depends on the ability to sense different spectrums of visible light and react based on those measurements, the ISL29125 breakout board may be just what you need. The ISL29125 breakout board makes it very easy to sense and record the light intensity of the general red, green, and blue spectrums of visible light while rejecting IR from light sources. You can then use these sensor readings for the purposes of logging and finding patterns, or creatively calculate and make control decisions in your electronic projects.