Search results for: 'audio breakout'

50 results

Adafruit I2S 3W Class D Amplifier Breakout - MAX98357A

Brand: Adafruit
Listen to this good news - Adafruit now have an all in one digital audio amp breakout board that works incredibly well with the Raspberry Pi! If you're looking for an...
$10.65 AUD, inc GST

Adafruit I2S MEMS Microphone Breakout - ICS-43434

Brand: Adafruit
Listen to this good news - we now have a breakout board for a super tiny ICS43434 I2S MEMS microphone. Just like 'classic' electret microphones,...
$15.22 AUD, inc GST

Adafruit PCM5102 I2S DAC with Line Level Output - 112dB SNR

Brand: Adafruit
We stock a lot of chips and development boards that are able to do high quality digital I2S out, which makes for great quality audio playback. That's...
$8.95 AUD, inc GST

Teensy Audio Adapter Board (Rev D)

Brand: Teensy
This is the Teensy Audio Adapter Board that can be added to a Teensy 4.0 for your next audio project. The shield provides you with an easy-to-use tool to add high...
$16.40 AUD, inc GST

SparkFun I2S Audio Breakout - MAX98357A

Brand: Sparkfun
The SparkFun I2S Audio Breakout board uses the MAX98357A digital to analog converter (DAC), which converts I2S (not be confused with I2C) audio to an analog signal...
$12.30 AUD, inc GST

Sound input module (4-pin)

Brand: Core Electronics

An all-in-one module for easily sensing sound!

$1.20 AUD, inc GST

OpAmp Breakout

Brand: Sparkfun
This is a simple Op Amp breakout board, set up as a 2-stage amplifier with a gain of 100 (gain of 10 for each stage). The on-board trim pot sets the signal level between the stages, not the feedback path. The bandwidth is set to 15.9kHz by a pair of feedback capacitors, or over 100kHz with the caps removed. The LMV358 opamp can source up to 160mA and works well as a low impedance driver/buffer.
$12.05 AUD, inc GST

TRRS 3.5mm Jack Breakout

Brand: Sparkfun
TRRS connectors are the audio-style connectors that you see on some phones, MP3 players and development boards. TRRS stands for “Tip, Ring, Ring, Sleeve,” which reflects the fact that, unlike a standard stereo connector, this actually has three conductors and a ground. Some devices use the extra conductor for a microphone (like hands-free headsets) or to carry a video signal (like in some MP3/MP4 players). This breakout board makes it easy to add a TRRS jack to your prototype or project by breaking out each conductor to a standard 0.1" spaced header.
$7.55 AUD, inc GST

Voice Recorder Module-breakout

Brand: DFRobot
Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons...
$11.85 AUD, inc GST

Music Shield V2.0 (Seeed Studio)

Brand: Seeed Studio
Time to build your real-time MIDI instrument/music player! The Music Shield is an audio encoder/decoder compatible with Arduino, Seeeduino, Seeeduino Mega...
$49.15 AUD, inc GST

Adafruit I2S MEMS Microphone Breakout - SPH0645LM4H

Brand: Adafruit
Listen to this good news - Adafruit now have a breakout board for a super tiny I2S MEMS microphone. Just like 'classic' electret microphones, MEMS mics can detect sound...
$12.85 AUD, inc GST

Adafruit TLV320DAC3100 - I2S DAC with Headphone and Speaker Out

Brand: Adafruit
We stock a lot of chips and development boards that are able to do high quality digital I2S out, which makes for great quality audio playback. That's...
$13.10 AUD, inc GST

Adafruit PCM5100 I2S DAC with Line Level Output - 100dB SNR

Brand: Adafruit
We stock a lot of chips and development boards that are able to do high quality digital I2S out, which makes for great quality audio playback. That's...
$8.05 AUD, inc GST

Adafruit TRRS Jack Breakout Board

Brand: Adafruit
Tip-Ring-Ring-Sleeve style audio cables are often used for situations where you want stereo audio and then an extra contact for a microphone input. For...
$3.30 AUD, inc GST

Adafruit I2S Stereo Decoder - UDA1334A Breakout

Brand: Adafruit
This fully-featured UDA1334A I2S Stereo DAC breakout is a perfect match for any I2S-output audio interface. It's affordable but sounds great! The NXP UDA1334A is...
$14.05 AUD, inc GST

Stereo 20W Class D Audio Amplifier - MAX9744

Brand: Adafruit
Pump up the volume with this 20W stereo amplifier! This slim little board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers...
$39.20 AUD, inc GST

Adafruit PDM MEMS Microphone Breakout

Brand: Adafruit
An exotic new microphone has arrived in the Adafruit shop, a PDM MEMS Microphone! PDM is the 'third' kind of microphone you can integrate with electronics, apart...
$9.85 AUD, inc GST

Adafruit Silicon MEMS Microphone Breakout - SPW2430

Brand: Adafruit
Listen to this good news - Adafruit now have a breakout board for a super tiny MEMS microphone. Just like 'classic' electret microphones, MEMS mics can detect sound and...
$9.20 AUD, inc GST

Adafruit Audio FX Sound Board - WAV/OGG Trigger with 16MB Flash

Brand: Adafruit
Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers, you just want...
$45.20 AUD, inc GST

Adafruit Audio FX Sound Board + 2x2W Amp - WAV/OGG Trigger - 2MB

Brand: Adafruit

Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers. Adafruit's Audio FX Sound Board is the fastest way to add audio effects to a project! We think this is the best sound board for props and costumes!

$43.10 AUD, inc GST

Adafruit Audio FX Sound Board - WAV/OGG Trigger with 2MB Flash

Brand: Adafruit
Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers, you just want...
$34.65 AUD, inc GST

SparkFun Analog MEMS Microphone Breakout - SPH8878LR5H-1

Brand: Sparkfun
The SparkFun Analog MEMS Microphone Breakout makes it easy to work with the SPH8878LR5H-1 analog microphone from Knowles...
$15.15 AUD, inc GST

Stereo 3.7W Class D Audio Amplifier - MAX98306

Brand: Adafruit
This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a...
$16.35 AUD, inc GST

Audio Jack Breakout

Brand: Sparkfun
Simple breakout board for the 3.5mm audio jack. Use this breakout (shipped bare) to allow breadboard or SIP access to the super-common 3.5mm audio jack. All five pins are broken out.
$2.60 AUD, inc GST

Adafruit STEMMA Audio Amp - Mono 2.5W Class D - PAM8302

Brand: Adafruit
The Adafruit STEMMA Audio Amp is a super small mono amplifier is surprisingly powerful - able to deliver up to 2.5 Watts into 4-8 ohm impedance speakers....
$8.85 AUD, inc GST

Si4703 FM Tuner Basic Breakout

Brand: Sparkfun
This breakout for the Silicon Laboratories Si4703 FM tuner chip is a little more stripped down than our FM Tuner Evaluation Board. If your project already has an amp and just needs a full-featured FM tuner, this is the board for you. Beyond being a simple FM radio, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job of filtering and carrier detection. It also enables data such as the station ID and song name to be displayed to the user.
$23.20 AUD, inc GST

Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger 16MB Flash

Brand: Adafruit
Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers, you just want...
$34.55 AUD, inc GST

Adafruit Audio FX Sound Board + 2x2W Amp - WAV/OGG Trigger -16MB

Brand: Adafruit

This is a simple, low-cost audio effects trigger that is easy to use and does not require any programming!

$56.95 AUD, inc GST

Adafruit Audio FX Mini Sound Board - WAV/OGG Trigger - 2MB Flash

Brand: Adafruit
Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers, you just want...
$30.06 AUD, inc GST

WVR Audio Development Board

Brand: Sparkfun
WVR features 8GB of memory and an advanced Web GUI where users upload audio and manage configuration and firmware...
$99.50 AUD, inc GST

SparkFun Electret Microphone Breakout

Brand: Sparkfun

This small breakout board couples an Electret microphone (100Hz--10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knocks or any sounds loud enough to be picked up by a microcontroller’s analog-to-digital converter.

$16.45 AUD, inc GST

Adafruit Music Maker MP3 Shield for Arduino w/3W Stereo Amp - v1.0

Brand: Adafruit
Bend all audio files to your will with the Adafruit Music Maker shield for Arduino! This powerful shield features the VS1053, an encoding/decoding (codec) chip that...
$60.95 AUD, inc GST

Audio Jack - 3.5mm TRRS (SMD)

Brand: Sparkfun
This is a 3.5mm TRRS SMD audio jack. TRRS connectors are the audio-style connectors that you see on some phones, MP3 players and development boards. TRRS stands for “tip, ring, ring, sleeve,” which reflects the fact that, unlike a standard stereo connector, this actually has three conductors and a ground. Some devices use the extra conductor for a microphone (like hands-free headsets) or to carry a video signal (like in some MP3/MP4 players).
$2.15 AUD, inc GST

SparkFun Audio Player Breakout - MY1690X-16S

Brand: Sparkfun
The SparkFun M71690X-16S Audio Player Breakout is a compact serial-controlled audio player designed around the MY1690X-16S decoder that supports both .WAV...
$26.60 AUD, inc GST

SparkFun Audio Codec Breakout - WM8960 (Qwiic)

Brand: Sparkfun
The SparkFun WM8960 Audio Codec Breakout is a low-power, high-quality stereo codec with 1W Stereo Class D speaker drivers and headphone drivers...
$30.20 AUD, inc GST

Mono Audio Amp Breakout - TPA2005D1

Brand: Sparkfun
This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery life. It can drive an 8-Ohm speaker at up to 1.4 Watts; it won’t shake a stadium, but it will provide plenty of volume for your audio projects.
$17.40 AUD, inc GST

Adafruit PDM Microphone Breakout with JST SH Connector

Brand: Adafruit
An exotic new microphone has arrived in the Adafruit shop, a PDM MEMS Microphone! PDM is the 'third' kind of microphone you can integrate with electronics, apart...
$8.70 AUD, inc GST

VS1053 Codec + MicroSD Breakout - MP3/WAV/MIDI/OGG Play + Record - v4

Brand: Adafruit
This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis...
$43.40 AUD, inc GST

MP3 Trigger V24

Brand: Pololu
Make some noise with your next project! The MP3 Trigger board is built to make MP3 sound integration easy. The board has 18 external trigger pins that...
$98.65 AUD, inc GST

Tsunami Super WAV Trigger (Qwiic)

Brand: Sparkfun
Based on a new generation ARM Cortex M7, the Qwiic Tsunami extends polyphony to 32 mono or 18 stereo simultaneous uncompressed 44.1kHz, 16-bit tracks...
$174.95 AUD, inc GST
Feedback

Please continue if you would like to leave feedback for any of these topics:

  • Website features/issues
  • Content errors/improvements
  • Missing products/categories
  • Product assignments to categories
  • Search results relevance

For all other inquiries (orders status, stock levels, etc), please contact our support team for quick assistance.

Note: click continue and a draft email will be opened to edit. If you don't have an email client on your device, then send a message via the chat icon on the bottom left of our website.

Makers love reviews as much as you do, please follow this link to review the products you have purchased.