Search results for: 'twisted pair'

This 6" (15cm) cable has two 26AWG conductors with a 2.5mm-pitch 2-pin female JST XH-style connector. The spacing is very close to 0.1", which means this connector will work with 0.1" male header pins and standard perfboards and solderless breadboards. The other ends of the wires are unterminated; they can be cut to length to match your application. The red and black wires are twisted together to reduce noise.

This 3ft Category 6 (CAT 6) Ethernet cable is the solution to your internet working needs. With a speed of up to 500MHz you can connect to your LAN/WAN segments and networking gear at maximum speed. Also, with its superior connector you get a cable that is built for speed and endurance.

This is a simple RS232 to RS485 converter that is self powered using the TX, RX or RTS, CTS signals for power. The RS232 is DB9 female connector, and the RS485 side is a DB9 male or 4 position terminal block.

This 24-inch (600-mm), twisted cable can be used to extend the leads of many common RC hobby servos. It has 22-AWG wires, and both the male and female cable ends are compatible with both JR- and Futaba-style connectors, allowing it to work in either system or as an adapter between systems. The cable’s conductors each consist of 60 strands, making it much more flexible than standard servo cables, and the wires are twisted to reduce electromagnetic interference (EMI).

This 12-inch (300-mm), twisted cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. It can be used to make connections between devices with 0.1" 3-pin male headers, such as between RC servo controllers or RC receivers and motor controllers with an RC interface. It can also be a convenient way to connect various 3-pin sensors to a robot controller. The cable’s conductors each consist of 60 strands, making it much more flexible than standard servo cables, and the wires are twisted to reduce electromagnetic interference (EMI).

This 12-inch (300-mm), twisted Y-cable can be used to split a single RC hobby servo signal into two identical outputs. It has 22-AWG wires terminated on all three ends by “JR”-style female connectors, which are compatible with 0.1" header bins and both male JR and male Futaba J connectors. The split occurs close to the cable’s input, so the two output ends can be separated by up to approximately 18" (450 mm). The cable’s conductors each consist of 60 strands, making it much more flexible than standard servo cables, and the wires are twisted to reduce electromagnetic interference (EMI).

This 6-inch (150-mm), twisted cable has 22-AWG wires and female “JR”-style connectors on both ends, the same kind of connector commonly found on RC hobby servos. It can be used to make connections between devices with 0.1" 3-pin male headers, such as between RC servo controllers or RC receivers and motor controllers with an RC interface. It can also be a convenient way to connect various 3-pin sensors to a robot controller. The cable’s conductors each consist of 60 strands, making it much more flexible than standard servo cables, and the wires are twisted to reduce electromagnetic interference (EMI).

This 12-inch (300-mm), flat Y-cable can be used to split a single RC hobby servo signal into two identical outputs. It has 22-AWG wires terminated on all three ends by “JR”-style female connectors, which are compatible with 0.1" header bins and both male JR and male Futaba J connectors. The split occurs close to the cable’s input, so the two output ends can be separated by up to approximately 18" (450 mm). The cable’s conductors each consist of 60 strands, making it more flexible than standard servo cables.

The RS485 Pi is a communication board supporting the RS-485 serial protocol.