Search results for: 'rp-sma to ufl/u.fl/ipx/ipex rf adapter cable'

The Interface Cable SMA to U.FL is a connector cable that interfaces U.FL RF connectors to regular SMA connections.

u.FL connectors are very small surface-mount parts used when an external RF antena is desired but a big bulky SMA connector takes up too much space. Adafruit use this part...

Most antennas have SMA or RP-SMA connectors on them, how are you going to connect them to your little RF module? This little cable will bridge the...

This SMA to U.FL Cable is commonly used to attach WiFi, Bluetooth, or nRFxxx based devices to a 2.4GHz antenna. What makes this unassuming cable special is...

A 433MHz antenna that utilizes an SMA connector and is 200mm long with a gain of 2dBi...

This SMA male to male is a quality cable able to handle 6GHz with very low attenuation. It is the perfect cable to connect the RF Explorer Signal Generator...

This is a 300mm (1 foot) Male TNC to Male SMA cable with injection molded stress-relief boots...

This is a nice, short U.FL to U.FL cable used to connect submodules and other RF devices to carrier boards. 50mm is length is long enough to reach, but...

This RF connector is ideal to use RF Explorer deployed horizontally, with any antenna connected onto it. For instance when you are on the road and you...

2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4" long.

N-type to SMARS Cable to connect LoRa Gateway to Fibreglass antenna and extend the coverage...

PCB edge mount - SMA RF connector. Perfect for prototyping with the GPS and Cellular devices that require an antenna connection. These connectors have a female signal pin and will correctly mate with the original SMA type antennas.

All RF connectors wear with use. The RF Explorer SMA ports are subject to minimal wear each time the connector interface is coupled and de-coupled with...

After years of popularity with the XBee Series 1 and XBee Series 2 Pro Modules, we now have the XBee Series 3 Pro which brings the best of both worlds. XBee 3 not...

This SMA male to female is a quality cable able to handle 6GHz with very low attenuation. It is the perfect cable to connect the RF Explorer Signal Generator...

RF cables are required when connecting RF Explorer to other instruments or devices. This 50cm cable is good for any frequency up to 3GHz, and can fit RF...

After years of popularity with the XBee Series 1 and XBee Series 2, we now have the XBee Series 3 which brings the best of both worlds. XBee 3 not only handles 802.15.4...

This 2.4"/61mm long antenna has 2dBi of gain and 50O impedance so it will work fantastically with just about any 850/900/1800/1900/2100 wireless receiver/transmitter...

This is a 10 meter (33 ft) long Male TNC to Male SMA cable with injection molded stress-relief boots...

This cute little coax is a champ in our RF kit out! It has a right angle female U.FL (aka I-PEX) connector on both ends. Now instead of jerry-rigging a few U.FL...

900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long.

Need range? 2.4GHz Large Duck Antenna 5dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance.

When experimenting with GPS or RF it can be very handy to have the antenna on the top of your house or car with a clear view of the sky while you stay in d...