Search results for: 'inter-integrated circuit header'

A pack of the most commonly used headers!

Need another HAT on top of the stack? Grab one of these stacking headers!

A classic 0.1" | 2.54mm pitch 40-pin header row, with right-angle mounting for the edge of your board.

Configure your stack of Pico HATs however you want with this header kit!

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

This long row of headers has you covered when you have an "unconventional" free 40-pins on the edge of your PCB to interface or prototype with.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Great for low-profile designs or prototyping with DIP IC's.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

Got 8-pins on the edge of your PCB that you need to interface off a right right-angle? If so, this is the header for you.

If you've got exactly twenty positions for pins on the edge of your board you want some female headers on to interface with, these headers have you covered.

A header for twelve points on a PCB in a row that you want to connect to.

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

Need a customisable connector for random projects?

For four pin positions you require a four pin header for, this ought to do the trick.

For six pins you need to interface to at a right angle, these headers would be an easy option.

Need a simple three pin connection parallel to your board? There are not many easier options than a female header such as this.

A must have for your own low-profile PCB designs!

These are the headers to use when you need a full twelve pins on the edge of your board connected to from the side.