Showing results for surface-mount device header

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

A must have for your own low-profile PCB designs!







Create your own low-profile board designs with these super low-profile headers!











A pack of the most commonly used headers!


Need another HAT on top of the stack? Grab one of these stacking headers!


A classic 0.1" | 2.54mm pitch 40-pin header row, with right-angle mounting for the edge of your board.



Configure your stack of Pico HATs however you want with this header kit!

Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.


If stacking your boards too high is an issue check out this range of low-profile headers!

This long row of headers has you covered when you have an "unconventional" free 40-pins on the edge of your PCB to interface or prototype with.

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

If stacking your boards too high is an issue check out this range of low-profile headers!

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

For six pins you need to interface to at a right angle, these headers would be an easy option.

Got 8-pins on the edge of your PCB that you need to interface off a right right-angle? If so, this is the header for you.

If you've got exactly twenty positions for pins on the edge of your board you want some female headers on to interface with, these headers have you covered.

If stacking your boards too high is an issue check out this range of low-profile headers!
Makers love reviews as much as you do, please follow this link to review the products you have purchased.