Search results for: 'pcb risers'

Perfect for prototyping, the stacking header lets your signal and power flow through your project, grab a few and put your ideas to the test!

Suitable for all kinds of circuit boards, sensors, mechanical support of the installation. They are great for building a multi-level robot chassis. This 10-pack of standoffs includes 10 sets screws and nuts for securing the top of the standoff to your project.

Give yourself a lift with this 2x20 female socket header that has slightly longer than usual pins. You can plug this into your Raspberry Pi GPIO port and then plug...

Suitable for all kinds of circuit boards, sensors, mechanical support of the installation.

This 0.1mm pitch 2x2 Female Header is the perfect boost to use with boards that use the 4-pin 'PoE' header on the Raspberry Pi 3 and 4, like the Raspberry Pi PoE HAT! It's a great pairing to the 2x20 socket riser header to get a full lift.

Suitable for all kinds of circuit boards, sensors, mechanical support of the installation.

Having difficulty attaching a PCB? This kit is especially useful when there are no mounting holes - as with the original Raspberry Pi. Instead of gluing, taping...

This is an 8-pin female header, with extra long legs -- great for stacking Arduino shields.Pins are spaced by 0.1".

These nylon standoffs are ¾" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table.

Suitable for all kinds of circuit boards, sensors, mechanical support of the installation. They are great for building a multi-level robot chassis.

These two Female Stacking Headers alone are, well, lonely. But pair them with any of our Feather boards and you're in business! What do they do? They stack. Put...

These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table.

This extra-tall stackable 40-pin female header features two rows of 20 pins spaced with a 0.1″ (2.54 mm) pitch. It includes three 0.1″-thick spacers for additional clearance, and the extended pins allow multiple units to be stacked as popularized on Arduino shields. The 2×20 size is notably used on the Raspberry Pi Models A+ and B+, and the extra 0.3″ of height allows for stacked boards to clear all of the components on the Raspberry Pi B+.

Headers are like the duct tape of electronics. They're great for connecting things together, soldering to perf-boards, sockets for wires or break-away header, etc...

This is a 2x23 pin female PTH header, with extra long legs which makes great for stacking. This piece is in the common configuration for Beaglebone Black headers. Each pin has a spacing of 0.1" in between each other.