Search results for: 'gpio breakout board'

If you're after a quick and easy to way to connect external circuitry up to your Raspberry Pi, then look no further! This breakout board has a form factor perfect for connecting to breadboards using the included 40-pin ribbon cable.

Wouldn't it be cool to drive a tiny OLED display, read a color sensor, or even just flash some LEDs directly from your computer? Sure you can program an Arduino...

This is the assembled version of the Pi T-Cobbler Plus. This cobbler will break out your Pi's GPIO pins, with a labelled circuit board making prototyping easy like it should be.

The Breakout Pi Plus is a useful and versatile prototyping expansion board for the Raspberry Pi.

The Breakout Pi Zero is a useful and versatile prototyping expansion board for the Raspberry Pi Zero computer.

This pre-built Edge Connector Breakout Board for the BBC micro:bit gives access to all the important pins on the bottom edge of the BBC micro:bit.

This slice of PCB is a one-to-one reference for the Raspberry Pi GPIO. If you're prototyping, this can save you a lot of hassle by helping prevent wiring problems. It's designed to slip over the GPIO header and give you a label right next to each pin.

The Raspberry Pi A+/B+/Pi 2/Pi 3/Zero has landed on the Maker World like a 40-GPIO pinned, quad-USB ported, credit card sized bomb of DIY joy. And while you can...

This one is for all the makers and designers who want to use terminal blocks with the Pico's GPIO. The Terminal GPIO Expansion allows you to use both...

Now at right angles! An easy, solderless, swappable way to use breakouts with your Raspberry Pi 400 - just pop up to three Breakout Garden breakouts (2 x I2C, 1 x SPI) into the slots and get coding and creating!

We put a PermaProto half-sized proto board in a blender with a Pi Cobbler and out emerged this very tasty confection - the 40-Pin PermaProto for Pi! It has the Cobbler...

The Ring:bit V2 extension board is a simplified extension circuit board based on the micro:bit.

Grow your projects on Breakout Garden. It's the easiest way to use breakouts with your Raspberry Pi. There's no soldering required, just pop up to six Pimoroni breakouts into the slots on Breakout Garden and get started coding and creating.

Are you low on I/O? No problem! The SX1509 Breakout is a 16-channel GPIO expander with an I2C interface – that means with just two wires, your microcontroller can interface with 16 fully configurable digital input/output pins. But the SX1509 can do so much more than just simple digital pin control. It can produce PWM signals, so you can dim LEDs. It can be set to blink or even breathe pins at varying rates. And, with a built-in keypad engine, it can interface with up to 64 buttons set up in an 8x8 matrix.