Search results for: 'breakaway male header'

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and six microstep resolutions (down to 1/32-step). It operates from 8.2 V to 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling). The driver has a pinout and interface that are nearly identical to those of Pololu's A4988 stepper motor driver carriers, so it can be used as a higher-performance drop-in replacement for those boards in many applications. This board ships with 0.1″ male header pins included but not soldered in.

Our Black Edition A4988 stepper motor driver carrier is a higher-performance drop-in replacement for the original A4988 stepper motor driver carrier. It features a four-layer PCB for better thermal performance, allowing the A4988 microstepping bipolar stepper motor driver to deliver approximately 20% more current than Pololu's two-layer (green) version. Like Pololu's original carrier, the Black Edition offers adjustable current limiting, over-current and over-temperature protection, and five different microstep resolutions. It operates from 8 V to 35 V and can deliver up to 2 A per coil with sufficient additional cooling. This board ships with 0.1″ male header pins included but not soldered in.

Never get frustrated with 2mm-pitch modules again! Each one of these 40-pin break-apart header packs contains 5 pieces of 40-pin, 2mm pitch headers. Great for when...

Single row of 30-holes, female header with swiss round machined pins. These units have very high quality round pins to accept and retain machine pin headers much better. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use them extensively in the Olimex development boards. They mate very well with break away headers.

If your soldering isn't quite up to scratch, or you yet don't own a soldering iron, then these nifty 0.1"/2.54mm standard pitch press-fit...

These are a longer version of our standard break away headers. They are 20mm long which allows you use them socket to socket. The plastic separator can be slid up or down to accommodate your needs.

This is a simple 2x3 male PTH header. This header is in the common configuration for an ISP connector. Each pin has a spacing of 0.1" in between each other.

This is a simple 2x8 male PTH header. This header is that you will find commonly used to interface with a basic 8x2 character LCDs. Each pin has a spacing of 0.1" in between each other.

This custom connector is a double-row, 14-pin, extended (22.85 mm) male header strip. Pololu include this connector with Pololu's 3pi expansion kits for connecting the expansion PCB to the 3pi robot.