


Add a power connector to your SMD PCB designs with this JST-PH 2-pin compatible connector...








These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.







Two pin JST PH 2mm connector to a 2.1x 5.5mm barrel jack, 6.25 inch long jumper cable. We use this cable to adapt from a wall power supply to a relatively small, SMD JST connector. We found that many of the SMD connectors used for battery charging were too large or were not capable of through-putting the current we wanted for faster charging. This setup, with a SMD JST connector and wall power supply, can handle up to 2A!

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

















Perfect for prototyping, these straight female headers are a super common header type so grab a few and put your ideas to the test!




Great for low-profile designs or prototyping with DIP IC's.
Makers love reviews as much as you do, please follow this link to review the products you have purchased.