Search results for: 'qwiic adapter'
PiicoDev Prototyping Cable (Male) 200mm
Brand: PiicoDev
This 200mm cable breaks out the four wires in a PiicoDev cable for manual wiring to breadboards or development boards. It's a 4-wire harness with an SH connector on one end and four Dupont-style connectors on the other.
$0.95 AUD, inc GST
PiicoDev Adapter for Breadboards
Brand: PiicoDev
The PiicoDev® Adapter for Breadboards allows you to break-out the 4-wires in a PiicoDev cable for prototyping on a breadboard.
$1.65 AUD, inc GST
STEMMA QT / Qwiic JST SH 4-pin Cable with Premium Female Sockets - 150mm Long
Brand: Adafruit
This 4-wire cable is a little over 150mm / 6" long and fitted with JST-SH female 4-pin connectors on one end and premium female headers on the other. Compared with...
$1.95 AUD, inc GST
JST SH 4-Pin to Premium Male Headers Cable - Qwiic Compatible - 150mm Long
Brand: Adafruit
This 4-wire cable is a little over 150mm / 6" long and fitted with JST-SH female 4-pin connectors on one end and premium Dupont male headers on the other. Compared...
$1.95 AUD, inc GST
PiicoDev Adapter for Raspberry Pi
Brand: PiicoDev
The PiicoDev® Adapter for Raspberry Pi is a great way to connect sensors to your Raspberry Pi without soldering.
$4.05 AUD, inc GST
Grove to STEMMA QT / Qwiic / JST SH Cable - 100mm long
Brand: Adafruit
Are you a maker in the midst of a STEMMA dilemma? This 100mm long cable is a fantastic chimera-cable fitted with STEMMA QT / Sparkfun Qwiic JST SH on one end, and...
$3.85 AUD, inc GST
Flexible Qwiic Cable - Female Jumper (4-pin)
Brand: SparkFun
This is a jumper adapter cable that comes pre-terminated with a female Qwiic JST connector on one end and female connectors on the other. The cable insulation is...
$3.30 AUD, inc GST
PiicoDev Adapter for Micro:bit
Brand: PiicoDev
Connect your Micro:bit with the outside world using PiicoDev® Adapter for Micro:bit. With this adapter you can experiment with sensors from the PiicoDev range giving your Micro:bit new sensing abilities.
$13.20 AUD, inc GST
SparkFun Qwiic Adapter
Brand: SparkFun
The SparkFun Qwiic Adapter provides the perfect means to make any old I2C board into a Qwiic-enabled board. This adapter breaks out the I2C pins from the Qwiic connectors...
$2.75 AUD, inc GST
SparkFun Qwiic SHIM for Raspberry Pi
Brand: SparkFun
The SparkFun Qwiic SHIM for Raspberry Pi is a small, easily removable breakout that easily adds a Qwiic connector to your Raspberry Pi. The SHIM design allows you...
$3.30 AUD, inc GST
Adafruit FT232H Breakout - General Purpose USB to GPIO, SPI, I2C - USB C & Stemma QT
Brand: Adafruit
Wouldn't it be cool to drive a tiny OLED display, read a color sensor, or even just flash some LEDs directly from your computer? Sure you can program an Arduino...
$27.80 AUD, inc GST
Qwiic Cable - Grove Adapter (150mm)
Brand: SparkFun
With the SparkFun Qwiic Connect System expanding every day, we want to make sure it becomes as accessible as possible but we understand there are other systems that...
$4.15 AUD, inc GST
Adafruit Pi Stemma QT Breakout for Raspberry Pi and Compatibles
Brand: Adafruit
The Adafruit Pi Stemma is a small, easily removable breakout that easily adds a 4-pin JST SH pin (Stemma QT or Qwiic) connector to your Raspberry Pi. The...
$4.55 AUD, inc GST
Breakout for JST SH-Style Connector, 4-Pin Male Side-Entry (2-Pack)
Brand: Pololu
These simple boards serve as adapters between a JST SH-style 4-pin male connector and breadboard-compatible 0.1"-pitch through holes.
$3.20 AUD, inc GST
Adafruit Qwiic / Stemma QT Breakout Board
Brand: Adafruit
We got a request from a customer for a board that makes connecting between a breadboard and Stemma QT or Qwiic components easy, and here's what we...
$3.80 AUD, inc GST
Adafruit SEN6x Breakout for Sensirion SEN66 - STEMMA QT / Qwiic
Brand: Adafruit
Now you can quickly integrate the Sensirion SEN6x environmental sensor node into your microcontroller or microcomputer project, with no soldering or...
$7.95 AUD, inc GST
SparkFun Qwiic HAT for Raspberry Pi
Brand: SparkFun
The SparkFun Qwiic HAT for Raspberry Pi is the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using that Raspberry Pi that you’ve...
$11.20 AUD, inc GST
WisBlock QWIIC Module RAK13009
Brand: RAKwireless
Connect QWIIC, STEMMA QT and PiicoDev modules to WisBlock in a sensor slot using a compact JST-SH interface for flexible IoT prototyping.
$4.95 AUD, inc GST
Pololu Isolated USB-to-I²C Adapter with Isolated Power
Brand: Pololu
This USB-to-I²C adapter enables a PC or other USB host to act as the controller on an I²C bus, reading and writing data from I²C target devices connected...
$24.60 AUD, inc GST
SparkFun Qwiic Shield for Arduino
Brand: SparkFun
The SparkFun Qwiic Shield is an easy-to-assemble board that provides a simple way to incorporate the Qwiic Connect System with your Arduino-based device. This shield...
$14.05 AUD, inc GST
Adafruit QT 5V to 3V Shifter Breakout - STEMMA QT / Qwiic
Brand: Adafruit
If you're hankerin' to use the new Qwiic / Stemma QT standard for your next project - but you're still using a classic Arduino UNO or other 5V microcontrollers, this board is designed for you!
$5.90 AUD, inc GST
SparkFun QwiicBus - EndPoint
Brand: SparkFun
The SparkFun QwiicBus EndPoint is the fastest and easiest way to extend the range of your I2C communication bus. The breakout uses NXP’s PCA9615 IC, which converts...
$24.90 AUD, inc GST
SparkFun Qwiic pHAT V2.0 for Raspberry Pi
Brand: SparkFun
The SparkFun Qwiic pHAT V2.0 for Raspberry Pi provides you with the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using that Raspberry...
$13.25 AUD, inc GST
Adafruit QT 3V to 5V Level Booster Breakout - STEMMA QT / Qwiic
Brand: Adafruit
If you're looking to use the Qwiic / Stemma QT standard for your next project - but you're using a sensor or device that requires 5V power or...
$6.15 AUD, inc GST
Pololu Isolated USB-to-I²C Adapter
Brand: Pololu
This USB-to-I²C adapter enables a PC or other USB host to act as the controller on an I²C bus, reading and writing data from I²C target devices connected...
$19.45 AUD, inc GST
JST-SH 4-pin Cable with Micro SMT Test Hooks - STEMMA QT / Qwiic
Brand: Adafruit
This cable will make it super easy to use our plug-and-play STEMMA QT boards and controllers with chips, breakouts, and other devices that are I2C compatible but don't come with a STEMMA QT socket already on 'em.
$5.70 AUD, inc GST
Qwiic 1.8V Adapter
Brand: SparkFun
Our Qwiic Connect System is designed to help you quickly interface development boards and breakouts in your project or pr...
$13.30 AUD, inc GST
SparkFun Qwiic pHAT Extension for Raspberry Pi 400
Brand: SparkFun
The SparkFun Qwiic pHAT Extension for the Raspberry Pi 400 provides you with a quick and easy solution to access all of the 400's GPIO, stack your favorite HAT right-side...
$13.10 AUD, inc GST
SparkFun QwiicBus Kit
Brand: SparkFun
The SparkFun QwiicBus Kit comes with everything you need to get started with the SparkFun QwiicBus system in one handy package. The kit includes two QwiicBus EndPoints...
$85.10 AUD, inc GST
SparkFun Qwiic Shield for Thing Plus
Brand: SparkFun
The SparkFun Qwiic Shield for Thing Plus provides you with a quick and easy way to enter into SparkFun's Qwiic ecosystem with your Thing Plus or Feather boards...
$9.65 AUD, inc GST
STEMMA QT / Qwiic JST SH 4-Pin Cable - 50mm Long
Brand: Adafruit
This 4-wire cable is 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead...
$1.85 AUD, inc GST
JST SH 4-Pin Cable - Qwiic Compatible - 100mm Long
Brand: Adafruit
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch...
$1.90 AUD, inc GST
STEMMA QT / Qwiic JST SH 4-Pin Cable - 200mm Long
Brand: Adafruit
This 4-wire cable is a little over 200mm / 7.8" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm...
$2.55 AUD, inc GST
Adafruit Qwiic / Stemma QT 5 Port Hub
Brand: Adafruit
Qwiic, or STEMMA QT, is a very efficient way to quickly prototype an idea, but a lot of Qwiic/Stemma QT driver boards only have one port, and devices have...
$4.95 AUD, inc GST
STEMMA QT / Qwiic JST SH 4-Pin Cable - 400mm long
Brand: Adafruit
This 4-wire cable is a little over 400mm / 15.7" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH...
$3.25 AUD, inc GST
Flexible Qwiic Cable - 50mm
Brand: SparkFun
This is a 50mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications...
$2.75 AUD, inc GST
Adafruit MCP2221A Breakout - General Purpose USB to GPIO ADC I2C - Stemma QT / Qwiic
Brand: Adafruit
Wouldn't it be cool to drive a tiny OLED display, read a color sensor, or even just flash some LEDs directly from your computer? Sure you can program an Arduino...
$12.30 AUD, inc GST
STEMMA QT / Qwiic JST SH 4-Pin Cable - 300mm long
Brand: Adafruit
This 4-wire cable is a little over 300mm / 11.8" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH...
$2.80 AUD, inc GST
Adafruit DS2484 I2C to 1-Wire Bus Adapter Breakout - STEMMA QT / Qwiic JST SH 1mm
Brand: Adafruit
By customer request, this is a DS2484 Stemma QT board that uses a I2C-to-1W controller chip, with ESD protection and support for split supplies. You can...
$14.10 AUD, inc GST
SparkFun Qwiic MultiPort
Brand: SparkFun
Qwiic is a very efficient way to quickly prototype an idea but not all Qwiic-enabled devices have two ports. The SparkFun Qwiic MultiPort adds additional ports to...
$4.30 AUD, inc GST
Makers love reviews as much as you do, please follow this link to review the products you have purchased.