Search results for: &#039;hy2.0 2-pin connector&#039;

Add a power connector to your SMD PCB designs with this JST-PH 2-pin compatible connector...

$0.26 AUD, inc GST

Two pin JST PH 2mm connector to a 2.1x 5.5mm barrel jack, 6.25 inch long jumper cable. We use this cable to adapt from a wall power supply to a relatively small, SMD JST connector. We found that many of the SMD connectors used for battery charging were too large or were not capable of through-putting the current we wanted for faster charging. This setup, with a SMD JST connector and wall power supply, can handle up to 2A!

$6.10 AUD, inc GST

Out of stock

Similar matches

Male Pin Header 2.54mm (1x40)

Perfect for prototyping, the straight male header is a super common header type so grab a few and put your ideas to the test!

$0.45 AUD, inc GST

2.54mm 1x40-Pin Right Male Header

A classic 0.1" | 2.54mm pitch 40-pin header row, with right-angle mounting for the edge of your board.

$0.41 AUD, inc GST

2.5mm Pitch 4-pin Cable Matching Pair - JST XH compatible

These solid 2.5mm pitch connector cable pairs are great when you need something that can carry a couple amps of current, easy to connect and disconnect, and is just-about 0.1" pitch compatible.

$2.10 AUD, inc GST

2.0mm Pitch 6-pin Cable Matching Pair - JST PH Compatible

These solid 2.0mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect and disconnect.

$2.35 AUD, inc GST

2.5mm Pitch 3-pin Cable Matching Pair - JST XH Compatible

These solid 2.5mm pitch connector cable pairs are great when you need something that can carry a couple amps of current, easy to connect and disconnect, and is just-about 0.1" pitch compatible.

$1.90 AUD, inc GST

2-Pin Female JST XH-Style Cable (15cm)

This 6" (15cm) cable has two 26AWG conductors with a 2.5mm-pitch 2-pin female JST XH-style connector. The spacing is very close to 0.1", which means this connector will work with 0.1" male header pins and standard perfboards and solderless breadboards. The other ends of the wires are unterminated; they can be cut to length to match your application. The red and black wires are twisted together to reduce noise.

$3.30 AUD, inc GST

2.5mm Pitch 2-pin Cable Matching Pair - JST XH compatible

These solid 2.5mm pitch connector cable pairs are great when you need something that can carry a couple amps of current, easy to connect and disconnect, and is just-about 0.1" pitch compatible.

$1.95 AUD, inc GST

2.0mm Pitch 5-pin Cable Matching Pair - JST PH Compatible

These solid 2.0mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect and disconnect.

$2.25 AUD, inc GST

2.5mm Pitch 6-pin Cable Matching Pair - JST XH compatible

These solid 2.5mm pitch connector cable pairs are great when you need something that can carry a couple amps of current, easy to connect and disconnect, and is just-about 0.1" pitch compatible.

$3.10 AUD, inc GST

Out of stock

2.5mm Pitch 5-pin Cable Matching Pair - JST XH compatible

These solid 2.5mm pitch connector cable pairs are great when you need something that can carry a couple amps of current, easy to connect and disconnect, and is just-about 0.1" pitch compatible.

$2.20 AUD, inc GST

40-Pin 2.54mm Round Female Pin Header

Great for low-profile designs or prototyping with DIP IC's.

$0.54 AUD, inc GST

2.0mm Pitch 3-pin Cable Matching Pair - JST PH Compatible

These solid 2.0mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect and disconnect.

$2.20 AUD, inc GST

2.54mm 1x2-Pin Straight Female Header

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

$0.11 AUD, inc GST

2-Pin Wire Joints (3-pack)

These are the easiest way possible to connect two wires - no if's, and's, or butt's! Well, actually, these are often referred to as wire butts 'cause you 'butt'...

$2.10 AUD, inc GST

Breakout for JST SH-Style Connector, 4-Pin Male Top-Entry (2-Pack)

These simple boards serve as adapters between a JST SH-style 4-pin male connector and breadboard-compatible 0.1"-pitch through holes. They work with our...

$3.15 AUD, inc GST

2.5 mm JST XH-Style Shrouded Male Connector: 2-Pin, Right Angle (4-Pack)

These shrouded, 2-pin JST XH-style male connectors have right-angle leads and match the female connector on the 2-pin female XH-style cable, and they also work with other many other 0.1″-pitch female connectors, such as Pololu's female premium jumper wires. They are sold in packs of four units.

$2.95 AUD, inc GST

2.0mm Pitch 4-pin Cable Matching Pair - JST PH Compatible

These solid 2.0mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect and disconnect.

$2.10 AUD, inc GST

Available with a lead time

Breakout for JST SH-Style Connector, 2-Pin Male Top-Entry (2-Pack)

These simple boards serve as adapters between a JST SH-style 2-pin male connector and breadboard-compatible 0.1"-pitch through holes. They work with our...

$2.80 AUD, inc GST

DC Barrel Plug to 2-Pin Terminal Block Adapter

This connector adapts a 5.5 × 2.1 mm DC barrel plug to a pair of screw terminals. The terminals are labeled positive and negative, with the positive terminal connected to the center contact.

$4.95 AUD, inc GST

Breakout for JST PH-Style Connector, 4-Pin Male Top-Entry, with SH

This simple board serves as an adapter between a JST PH-style 4-pin, top-entry connector and breadboard-compatible 0.1"-pitch through holes. The PH...

$2.80 AUD, inc GST

Breakout for JST SH-Style Connector, 4-Pin Male Side-Entry (2-Pack)

These simple boards serve as adapters between a JST SH-style 4-pin male connector and breadboard-compatible 0.1"-pitch through holes.

$3.20 AUD, inc GST

Breakout for JST SH-Style Connector, 5-Pin Male Side-Entry (2-Pack)

These simple boards serve as adapters between a JST SH-style 5-pin male connector and breadboard-compatible 0.1"-pitch through holes. They work with our...

$3.30 AUD, inc GST

Breakout for JST SH-Style Connector, 3-Pin Male Side-Entry (2-Pack)

These simple boards serve as adapters between a JST SH-style 3-pin male connector and breadboard-compatible 0.1"-pitch through holes. They work with our...

$2.95 AUD, inc GST

2.54mm 1x2-Pin Right Female Header

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

$0.17 AUD, inc GST