Search results for: 'grove cable'

This 200mm cable is for connecting PiicoDev modules together - it is a 4-wire harness with 1mm pitch SH connectors on each end.

Grove - Water Sensor detects the presence of water using exposed PCB traces. The sensor is made up of interlaced traces of Ground and Sensor signals. The...

HUB is a unit that is used in order to expand the GROVE ports over the M5Stack device. For example, if we want sensors with different IIC addresses or output to 3 devices at the same time. (M5Stack device usually can output one device at a time to to limited amount of grove ports)

The Relay is a digital normally open switch that controls a relay capable of switching much higher voltages and currents than your normal Arduino boards...

The Infrared Receiver is used to receive infrared signals and also used for remote control detection. There is a IR detector on the Infrared Receiver which...

It's used to convert the TTL standard to the RS485 standard. If the outside serial device is RS485 standard, you can attach this unit onto M5stack, therefore, to implement the communication with RS485 device by TTL protocol.

The Grove-125KHz RFID Reader is a module used to read uem4100 RFID card information with two output formats: Uart and Wiegand. It has a sensitivity with...

This module is based on the I2C light-to-digital converter TSL2561 to transform light intensity to a digital signal. Different from traditional analog...

The Grove Inventor Kit for micro:bit brings endless possibilities to your micro:bit, from robots to musical instruments. Using an array of modules like sensors, displays and actuators.

Simplifying Raspberry Pi Pico for Beginners Maker Pi Pico incorporates the most wanted Reset button for your Raspberry Pi Pico and gives you access to all...

HEART is built using the MAX30100 chipset. MAX30100 is a complete pulse oximetry and heart-rate sensor system solution designed for the demanding requirements of wearable devices. The MAX30100 provides very small total solution size without sacrificing optical or electrical performance. Minimal external hardware components are needed for integration into a wearable device.

The RTC module is a member of Twig. It is based on the clock chip DS1307 which supports the I2C protocol. It uses a Lithium cell battery (CR1225). The...

This is an easy to use and cost-effect PH sensor/meter, suitable for Arduino and Raspberry Pi, support 3.3V and 5V system...

This is a 4-pin, 2.0mm pitch, Grove Female Header pack with 20pcs, which is suitable to solder onto a module and enable it to connect with other...

Want to connect several Seeed Studio Grove modules to your Arduino board? The Arduino MKR CONNECTOR CARRIER is the perfect companion for Arduino MKR boards and a Grove ecosystem.

Since the advent of Internet of Things(IoT), developers all feel an urge to build a thing or two to introduce the IoT capabilities into their business...

Explore the M5Stack Mini CAN Bus Module, a compact communication module featuring high-speed data transfer up to 5Mbit/s, CAN FD protocol support, and wide voltage input range of 5-24V for automotive and industrial applications.

Learn to Plug, Sketch and Play with basic Grove sensors, actuators and Arduino. All the modules are pre-wired on the PCB, just connect your Arduino Board to the Shield and start your measurements!

The Grove Shield FeatherWing for Particle Mesh and all Feathers is an add-under for any Particle Mesh or Feather board, so that you can easily interface with Seeed's...

Discover the Seeed XIAO Starter Kit - Microcontroller Development Essentials, perfect for beginners and hobbyists. Learn the basics of microcontroller programming with this comprehensive kit featuring the Seeed XIAO board. Ideal for DIY electronics projects and prototyping.

This universal connector for your M5 Stack, connects to pin, commonly used of this part is for the RGB LED strip extension.