
If stacking your boards too high is an issue check out this range of low-profile headers!


If stacking your boards too high is an issue check out this range of low-profile headers!

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

Need a simple three pin connection parallel to your board? There are not many easier options than a female header such as this.













Perfect for prototyping, these straight female headers are a super common header type so grab a few and put your ideas to the test!

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins




Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.


For six pins you need to interface to at a right angle, these headers would be an easy option.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.




Grab a couple female headers for your Pico or Pico W!








Makers love reviews as much as you do, please follow this link to review the products you have purchased.