Search results for: 'rubber grommet'

Protect your electronic projects from rain and water splash using this waterproof IP68 enclosure. Made from high-quality ABS material, these boxes are sturdy and...

Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are Adafruit's favorite accessory for any electronic kit or device...

Here's an easy solution for keeping your USB A devices free from dust and other unsavory particulates. This squishy Silicone USB A Dust Cover Inserts slip neatly into any computer or device with a standard USB A socket.

A new tiny squishy delight! This Black Rubber Joystick Nubbin Cap is the perfect add-on to any of your projects with a 5-way navigation joystick, like the Adafruit Mini Color TFT with Joystick FeatherWing or Adafruit 128x64 OLED Bonnet for Raspberry Pi. Fits perfectly on classic 5-way navigation joysticks.

This rubber sheet is made of the same carbon-black impregnated rubber material that our conductive rubber cord uses. Traditionally it would be used for...

This is an 8 Pack of 12mm tall Rubber Feet

Store your project safe and sound in this nice weatherproof box with a clear top. they picked up this box because Adafruit like the machinable ABS plastic body and tough...

The 2.4 GHz whip antenna is a compact, omnidirectional high performance antenna for 2.4 GHz band including WiFi, ZigBee, Bluetooth, Video, ISM, etc. This...

Protect your board or project with this four pack of silicone bumpers! Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting...

This plastic locking grommet is made specifically for a 14mm hole in a 2.5mm thick part. The grommets snap in place with the wings which.....

This rubber sheet is made of the same carbon-black impregnated rubber material that our conductive rubber cord uses. Traditionally it would be used for...

Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a project down on a conductive surface. They also prevent your enclosure or PCB from sliding around. They can also be used as feet for enclosures. These are self-adhesive and 16.5mm in diameter and about 10mm tall. They taper to roughly 12mm at the top. They come in a set of 4.

This rubber ring is used to afix ultrasonic sensor. It fits URMV3.2 and URM04.

Here is a powerful, low-cost, reliable servo for all your mechatronic needs. This servo is able to take in 6 volts and deliver 83.47 oz-in. of maximum torque at 0.16 sec/60°

These beefy, bright red plastic enclosures will give your widget the protection (and attention) it deserves. You’ve probably seen these used to enclose radio equipment or antenna baluns as they can be secured to a pole using U-bolts (not included). At about 3mm thick, this 74x158x90mm enclosure has plenty of space for gizmos, gadgets, widgets and doohickeys. The mounting flanges extend 19mm from either edge with two 50mm-spaced 7mm diameter holes.

By popular demand! Adafruit now have the plates from the ARDX available separately. Acrylic plate is engraved and cut here at the Adafruit factory. There are mounting...