Search results for: 'grommets'

Protect your board or project with this four pack of silicone bumpers! Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting...

Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a project down on a conductive surface. They also prevent your enclosure or PCB from sliding around. They can also be used as feet for enclosures. These are self-adhesive and 16.5mm in diameter and about 10mm tall. They taper to roughly 12mm at the top. They come in a set of 4.

Keep dust and debris out of your project with this Debris-Shield! This plastic component is designed to mount to 6mm thick material (such...

This is a white spiral cable guide. This spiral makes it very easy to control your cables after they've already been plugged in, or when you have many cables going to differnet places.

Here's an easy solution for keeping your Ethernet ports free from dust and other unsavory particulates. These squishy Silicone RJ-45 Dust Cover Inserts slip neatly into any computer or device with an Ethernet socket, from the Ethernet FeatherWing to the Raspberry Pi 4.

This is a simple pair of screw clamps to help secure your project when mounting. These are the same clamps that come with the Weather Meter Kit...

These beefy, bright red plastic enclosures will give your widget the protection (and attention) it deserves. You’ve probably seen these used to enclose radio equipment or antenna baluns as they can be secured to a pole using U-bolts (not included). At about 3mm thick, this 74x158x90mm enclosure has plenty of space for gizmos, gadgets, widgets and doohickeys. The mounting flanges extend 19mm from either edge with two 50mm-spaced 7mm diameter holes.