


A pack of the most commonly used headers!




If stacking your boards too high is an issue check out this range of low-profile headers!

If stacking your boards too high is an issue check out this range of low-profile headers!

If stacking your boards too high is an issue check out this range of low-profile headers!

A header for twelve points on a PCB in a row that you want to connect to.

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

Got 8-pins on the edge of your PCB that you need to interface off a right right-angle? If so, this is the header for you.



Need a simple three pin connection parallel to your board? There are not many easier options than a female header such as this.



Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.


These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.









A must have for your own low-profile PCB designs!


These are the headers to use when you need a full twelve pins on the edge of your board connected to from the side.





Makers love reviews as much as you do, please follow this link to review the products you have purchased.