Showing results for low profile female header

If stacking your boards too high is an issue check out this range of low-profile headers!

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

This long row of headers has you covered when you have an "unconventional" free 40-pins on the edge of your PCB to interface or prototype with.

If stacking your boards too high is an issue check out this range of low-profile headers!

For six pins you need to interface to at a right angle, these headers would be an easy option.


Need a simple three pin connection parallel to your board? There are not many easier options than a female header such as this.

A header for twelve points on a PCB in a row that you want to connect to.

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

For four pin positions you require a four pin header for, this ought to do the trick.









If you need ten points connected to on the edge of a board to connect to inline with the surface of the PCB, these headers should do the trick.



Create your own low-profile board designs with these super low-profile headers!

Perfect for prototyping, these straight female headers are a super common header type so grab a few and put your ideas to the test!

Configure your stack of Pico HATs however you want with this header kit!

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

Great for low-profile designs or prototyping with DIP IC's.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.





These are the headers to use when you need a full twelve pins on the edge of your board connected to from the side.


Grab a couple female headers for your Pico or Pico W!




Makers love reviews as much as you do, please follow this link to review the products you have purchased.