Search results for: 'interface cable'

The Interface Cable SMA to U.FL is a connector cable that interfaces U.FL RF connectors to regular SMA connections.

This 4-wire cable is 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead...

Are you a maker in the midst of a STEMMA dilemma? This 100mm long cable is a fantastic chimera-cable fitted with STEMMA QT / Sparkfun Qwiic JST SH on one end, and...

This is a basic SMA (Sub-Miniature A) male to female connector cable. Each cable is 25cm (9.8") long and has a 50Ω impedance that can handle frequencies up to 17 GHz. The SMA connectors at each end are small enough for most consumer GPS, cellular, and other RF applications and they use a threaded housing to create strong mechanical connections.

This is a basic SMA male to female connector cable at 25cm in length and RG174 housing...

This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch...

This is a basic RP-SMA male to female connector cable at 1M in length and RG174 housing...

A USB 2.0 extension cable designed to achieve distances up to 5m

This 12" (30 cm), 6-conductor ribbon cable has a female 2×3 IDC connector on each end that is designed to plug into a 0.100" (2.54 mm) 2×3 shrouded box header. It can also be used with 0.100" male header pins.

This 10m (33') SMA extension does a great job of connecting your receiver or radio to a distant antenna with as little RF loss as possible...

This is a 300mm (1 foot) Male TNC to Male SMA cable with injection molded stress-relief boots...

This is a basic RP-SMA male to female connector cable at 10M in length and RG58 housing...

This is a basic RP-SMA male to female connector cable at 25cm in length and RG174 housing...

This is a 10 meter (33 ft) long Male TNC to Male SMA cable with injection molded stress-relief boots...

Connect this to that with an IDC cable! This cable has 10 pins (2x5) in 0.1"x0.1" spacing. Often used for programming AVRs. 6" long with two sockets crimped onto...

This basic cable comes with two 3.5mm (1/8" headphone jack size) stereo connectors. It's fairly straight forward, you'll commonly need these to connect two audio...

This connector cable interfaces N type female to RP-SMA male. Primarily used to connect our larger 915MHz LoRa antenna to RP-SMA connections but can be used on other...

This is a basic SMA male to female connector cable at 1M in length and RG174 housing...

This here is your standard A-B USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your Arduino, USBtinyISP, or USB Boarduino (among other things). 6"...