empowering creative people

Relay Shield v2.0

SKU: DEV-13769

$21.59 AUD, inc GST
$19.63 AUD, exc GST

More Views

Relay Shield v2.0
21.59 AUD

SKU: DEV-13769

$21.59 AUD, inc GST
$19.63 AUD, exc GST
In stock, with a short lead time. 34 units dispatch in 3 to 6 days (in addition to the shipping method you choose). Our timing and stock is accurate. Delivery to you by Wed, 23rd of Aug with Express Post within Australia.

This Relay Shield v2.0 from Evil Mad Scientist is a simple Arduino add-on that gives your Arduino the ability to control a single electromechanical relay for switching loads of up to 24VDC or 40VAC. Each Relay Shield comes equipped with a single pole - double throw (SPDT) sealed relay which can handle a current load of up to 5A. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC (Normally Closed) contact to ground and closing the NO (Normally Open) contact. Use them to switch high voltage/high current devices. As this is a shield, it is powered straight from the 5V power supplied by your Arduino, simply slide it into your Arduino or shield-compatible board (like the RedBoard) and you will be good to go!

The relay shield is controlled through pin Digital 4 on your Arduino via a transistor labeled “Q1”. When output Digital 4 on your Arduino is low, the relay shield will connect the NC pin to the “Common” pin of the screw terminal. When output Digital 4 goes high, the “Coil On?” LED will light up and the relay shield will instead connect the NO pin to the “Common” pin of the screw terminal. Version 2.0 of this shield adds the ability to control the mechanical relay from a pin other than D4.

The Relay Shield is sold as an easy-to-assemble kit and includes everything listed below with clear assembly instructions listed in the documents section.

Includes:

  • 1x Relay Shield PCB
  • 1x GSLA SPDT 5A Relay
  • 1x Red LED, 3mm
  • 1x 100uF 10V Capacitor
  • 1x 0.1uF 25V Capacitor
  • 1x 2N4401 Transistor
  • 1x Screw Terminal, 3-pos
  • 1x Arduino Header Set
  • 2x 1000 ohm 1/4W Resistor
  • 2x 1N5817 Diode

Documents:

Documentation and Resources:

Product Comments

We deliver Australia-wide with these options:

  • $3 for Small Items (4-6 days, not tracked, only available on selected small items)
  • $6.95 for Standard Post (2-4 days, tracked)
  • $8.32 for Express Post (1-2 days, tracked)
  • Pickup - Free! Only available to customers who live in the Newcastle region

International Orders - the following rates are for New Zealand and will vary for other countries:

  • $11.49 for Pack and Track (3+ days, tracked)
  • $16.50 for Express International (2-5 days, tracked)

If you order lots of gear, the postage amount might increment based on the weight of your order.

Our physical address:

Unit 18, 132 Garden Grove Parade
Adamstown
NSW, 2289
Australia

Please checkout our customer service page if you have other frequently asked questions such as "do we do purchase orders" (yes!) or "are prices GST inclusive" (yes they are!). We're here to help - get in touch with us to talk shop.