Search results for: '30a fuse'

This is a common MOSFET with very low on-resistance and a control voltage (aka gate voltage) that is compatible with any 3-5V microcontroller...

When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit nicely...

Standard blade fuse 15 Amp

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 125VAC, up to 5A. Fuses are pretty simple, if more than 5A pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

This 3A panel mount push button single pole circuit breaker uses a snap acting bimetal element to sense current overload.

This is a handy little device that can save your system from smoking. A resettable fuse (also known as a PTC) is a resistor that has very unique properties.

The nested form-factor of this 12V battery allows it to be tucked away in an 1120 Series U-Channel to protect it from the moving pieces of your chassis.

This 5A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

You can use the multimeter to measure DC and AC voltage, DC and AC current, resistance, continuity, capacitance, frequency, and test diodes...

This is a 5mm PTH fuse clip intended to be used with our Glass Fuses.

This non-invasive current sensor (also known as a “split core current transformer”) can be clamped around the supply line of an electrical load to tell you how much current is passing through it. It does this by acting as an inductor and responding to the magnetic field around a current-carrying conductor. By reading the amount of current being produced by the coil, you can calculate how much current is passing through the conductor.

This 6V battery contains five 3000mAh sub-C cells wired in series. The high strand silicone wire has a built-in mini-blade fuse holder...

This ATM Series Mini Blade Fuse is the same fuse that comes pre-installed in the 3100-0006-0003 and 3100-0012-0020. Extra fuses are.....

TVS 1.5KE 30.8V 36ACA Standoff 1500W AC

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 250VAC, up to 500mA. Fuses are pretty simple, if more than 500mA pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

This 10A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.