Search results for: '2a fuse'

24V DC 2A switch mode plug pack...

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 125VAC, up to 5A. Fuses are pretty simple, if more than 5A pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

Standard blade fuse 15 Amp

This is a handy little device that can save your system from smoking. A resettable fuse (also known as a PTC) is a resistor that has very unique properties.

This 3A panel mount push button single pole circuit breaker uses a snap acting bimetal element to sense current overload.

This ATM Series Mini Blade Fuse is the same fuse that comes pre-installed in the 3100-0006-0003 and 3100-0012-0020. Extra fuses are.....

This 5A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

This 10A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 250VAC, up to 500mA. Fuses are pretty simple, if more than 500mA pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

The Soft Power Switch Mk2 is a passive, hard on/off switch with software feedback and control. In other words, it's like the on/off switch on a laptop. A s...

Typically used for garden lighting and water feature pumps these power supplies are ideal for outdoor use.

The SparkFun Soft Power Switch - JST 2mm is like the power button on your laptop, but for your own electronic creations!...

The LT3652 is a complete monolithic step-down battery charger that operates over a 4.95V to 32V input voltage range. The LT3652 provides a...

Arduino product family is a great learning platform for electronics, programming and robotics. But most projects at some point require mobility. This motor shield allows Arduino to drive two channel DC motors. It uses a L298P chip which deliveries output current up to 2A each channel. Stack up this shield on your controller and drive motors with higher power requirements. Depending on the motor of choice, you can make it fast or handle a higher payload. This Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC motors with maximum 2A current. This shield can be directly mounted onto standard Arduino Duemilanove and Arduino Mega.