Search results for: '1x4 straight pin header'

Perfect for prototyping, these straight female headers are a super common header type so grab a few and put your ideas to the test!

Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

A header for twelve points on a PCB in a row that you want to connect to.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

A classic 0.1" | 2.54mm pitch 40-pin header row, with right-angle mounting for the edge of your board.

Great for low-profile designs or prototyping with DIP IC's.

Great for low-profile designs or prototyping with DIP IC's.

Got two 0.1" seperated points on the edge of a board you need to connect to easily and permanently? In that case, there aren't many more simple options than a female header such as this.

Need a simple three pin connection parallel to your board? There are not many easier options than a female header such as this.

This long row of headers has you covered when you have an "unconventional" free 40-pins on the edge of your PCB to interface or prototype with.

If you've got exactly twenty positions for pins on the edge of your board you want some female headers on to interface with, these headers have you covered.

Need a customisable connector for random projects?