MicroView Bootloading Kit

SKU: KIT-13088 Brand: Sparkfun

Retired Product

Search for an alternative

This product has been retired. It is no longer available, but this page has been kept for reference.

MicroView, essentially an Arduino with a built-in display, is a tiny, enclosed piece of technology used to create a large assortment of electronics and programming projects. We understand that a lot of you really want to make the MicroView your own and get inside and reprogram it. We also, however, understand that that is not such an easy feat, luckily thatâ€™s where the MicroView Bootloading Kit comes in. This is an all-in-one kit that includes everything you will need to easily open and add, change, or remove a bootloader to/from your MicroView.

Each MicroView Bootloading Kit includes four basic parts to add a bootloader to your little OLED Arduino in the easiest way possible: SparkFunâ€™s own Tiny AVR Programmer to upload an ArduinoISP sketch or RedBoard drivers with the added benefit of not requiring a USB cable because it works with the MicroViewâ€™s included cable, a Hobby Knife to open the enclosure with the lowest potential of leaving scratches, a 30-pack of jumper wires for connecting the MicroView to the programmer if needed (youâ€™ll only need 6), and three 0 Ohm resistors in case you are lacking soldering tools and need to connect the MicroView to a breadboard. With these items combined you should experience no issues accessing and customizing your very own MicroView!

Note: In the Documents section below you will find a step-by-step guide on how to open up and load a bootloader on your MicroView. Itâ€™s a good read, check it out!

Includes:

1x Tiny AVR Programmer
1x Hobby Knife
30x Jumper Wire - M/M 180mm
3x Resistor - 0 Ohm 1/6W

Documents:

This product is listed in:

Retired

Product Comments

Start the conversation

Exact shipping can be calculated on the view cart page (no login required).

Products that weigh more than 0.5 KG may cost more than what's shown (for example, test equipment, machines, >500mL liquids, etc).

We deliver Australia-wide with these options (depends on the final destination - you can get a quote on the view cart page):

$3+ for Stamped Mail (typically 10+ business days, not tracked, only available on selected small items)
$6+ for Standard Post (typically 6+ business days, tracked)
$10+ for Express Post (typically 2+ business days, tracked)
Pickup - Free! Only available to customers who live in the Newcastle region (must order online and only pickup after we email to notify you the order is ready). Orders placed after 2PM may not be ready until the following business day.

Non-metro addresses in WA, NT, SA & TAS can take 2+ days in addition to the above information.

Some batteries (such as LiPo) can't be shipped by Air. During checkout, Express Post and International Methods will not be an option if you have that type of battery in your shopping cart.

International Orders - the following rates are for New Zealand and will vary for other countries:

$11+ for Pack and Track (3+ days, tracked)
$16+ for Express International (2-5 days, tracked)

If you order lots of gear, the postage amount will increase based on the weight of your order.

Our physical address (here's a PDF which includes other key business details):

Unit 18, 132 Garden Grove Parade
Adamstown
NSW, 2289
Australia

Take a look at our customer service page if you have other questions such as "do we do purchase orders" (yes!) or "are prices GST inclusive" (yes they are!). We're here to help - get in touch with us to talk shop.

Have a product question? We're here to help!

Write Your Own Review