Search results for: 'smd resistor pack'

These incredibly small surface-mount LEDs are an easy way to add a lot of very tiny (but bright!) colorful dots to your project. They are just mind-bogglingly small - 2mm square. As they are pretty darn tiny, they might be a bit difficult to hand solder. SMT techniques with solder paste and hot air will work best here.

Make your own smart LED arrangement with the same fancy side light integrated LED that is used in Adafruit's HalloWing M4, and side-emitting NeoPixel strip and pixels. These bare LEDs are a great alternative for folks who have loved and used Adafruit NeoPixel strips for a few years but want gorgeous, glowy light emitting at 90 degrees

The LT3652 is a complete monolithic step-down battery charger that operates over a 4.95V to 32V input voltage range. The LT3652 provides a...

These incredibly small surface-mount LEDs are an easy way to add a lot of very tiny (but bright!) colorful dots to your project. They are just mind-bogglingly small...

Make your own smart LED arrangement with the same integrated LED that is used in Adafruit's NeoPixel strip and pixels. This tiny 1515 (1.5mm x 1.5mm) RGB LED is designed...

Surface mount device , SMD, resistors are the most widely used electronic component. They're designed to have small metal tabs that could be directly soldered to the surface of the PCB.

2K4 1/2W - Same size as standard 1/4W carbon film.

1K1 1/2W - Same size as standard 1/4W carbon film.

75R 1/2W - Same size as standard 1/4W carbon film.

5K6 1/2W - Same size as standard 1/4W carbon film.

This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resistance will be larger than 1MΩ, with full pressure applied the resistance will be 2.5kΩ.