Search results for: 'fuse holders'

Standard blade fuse 15 Amp

This is a handy little device that can save your system from smoking. A resettable fuse (also known as a PTC) is a resistor that has very unique properties.

This 3A panel mount push button single pole circuit breaker uses a snap acting bimetal element to sense current overload.

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 125VAC, up to 5A. Fuses are pretty simple, if more than 5A pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

This 5A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

This ATM Series Mini Blade Fuse is the same fuse that comes pre-installed in the 3100-0006-0003 and 3100-0012-0020. Extra fuses are.....

This 6V battery contains five 3000mAh sub-C cells wired in series. The high strand silicone wire has a built-in mini-blade fuse holder...

This combination solder roll holder and soldering iron stand will keep your soldering iron off your working surface & your solder within easy reach. Accepts 200g and 1kg rolls of solder. Can be mounted on a wall or bench.

This 10A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

Self-fusing silicone electrical tape is the perfect way to insulate and protect your freshly-soldered splice...

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 250VAC, up to 500mA. Fuses are pretty simple, if more than 500mA pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

The CAN-BUS Shield provides your Arduino or Redboard with CAN-BUS capabilities and allows you to hack your vehicle. It uses the Microchip MCP2515 CAN controller with the MCP2551 CAN transceiver. CAN connection is via a standard 9-way sub-D for use with OBD-II cable. Ideal for automative CAN application. The shield also has a uSD card holder, serial LCD connector and connector for an EM406 GPS module. These features make this shield ideal for data logging application.