

Need another HAT on top of the stack? Grab one of these stacking headers!









A classic 0.1" | 2.54mm pitch 40-pin header row, with right-angle mounting for the edge of your board.

Great for low-profile designs or prototyping with DIP IC's.

Great for low-profile designs or prototyping with DIP IC's.

This long row of headers has you covered when you have an "unconventional" free 40-pins on the edge of your PCB to interface or prototype with.










Perfect for prototyping, these straight female headers are a super common header type so grab a few and put your ideas to the test!





Four header pins in a block for a permanent prototyping connection to your breakouts and PCBs.



Got a breakout board, microcontroller, or PCB of your choice you need to breakout ten pins from? If so, here's the run-of-the-mill header solution you're looking for.

These minature header blocks are perfect for when there are a couple points side-by-side you need to interface to.

Do you have a headerless breakout module, custom PCB, or other 2.54mm-pitch connection you need a reliable set of headers for? If so, then these are the kind of headers you're after.

This is a 1 × 8 set of 2.54mm | 0.1" separated female headers perfect for small microcontroller breakouts and similar boards to allow easy access to a row of pins

A header for twelve points on a PCB in a row that you want to connect to.


Got some 2.54mm | 0.1" pitch through holes on your PCB you need to connect to? Here's some headers you can use.

Need a customisable connector for random projects?

Makers love reviews as much as you do, please follow this link to review the products you have purchased.