Search results for: 'blade fuse'

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 125VAC, up to 5A. Fuses are pretty simple, if more than 5A pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

This is a handy little device that can save your system from smoking. A resettable fuse (also known as a PTC) is a resistor that has very unique properties.

This 3A panel mount push button single pole circuit breaker uses a snap acting bimetal element to sense current overload.

The nested form-factor of this 12V battery allows it to be tucked away in an 1120 Series U-Channel to protect it from the moving pieces of your chassis.

This 6V battery contains five 3000mAh sub-C cells wired in series. The high strand silicone wire has a built-in mini-blade fuse holder...

This 5A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

This 10A panel mount push button single pole circuit breaker uses a snap-acting bimetal element to sense current overload.

It’s like an Xacto knife, only better. We use these extensively when working with PCBs. These small knives work well for cutting traces, scraping ground pours, and guiding hair-like wires into their proper place. Excel knife comes with aluminum handle, one ultra-sharp blade, and safety cap.

This is a glass ferrule type fuse. It fits great with our 5mm fuse clips. The fuse is rated for 250VAC, up to 500mA. Fuses are pretty simple, if more than 500mA pass through the fuse, the small filament inside the fuse heats up and breaks (like a light bulb burning out). The circuit is then broken and hopefully your circuit is saved from molten destruction.

This is the stainless steel blade the Zumo 32U4 robot. It is included as part of the Zumo 32U4 Robot Kit and built into the assembled versions of the Zumo 32U4 Robots. The plastic IR LED holder is included.

This is a very simple board that takes a 6-12V input voltage and outputs a selectable 5V or 3.3V regulated voltage. All headers are 0.1" pitch for simple insertion into a breadboard.